Suspension front suspension ball for LADA 2108, 2110, Priora, Kalina, a series СomfortPRO

BRACKET BALL front suspension for LADA 2108, 2110, PRIORA, KALINA, SERIES СOMFORTPRO

The main causes of failure of the ball bearings (ball studs front suspension are:
 Insufficient strength of the ball joint, resulting in their destruction due to insufficient strength of the support body, the ball stud and the lack of strength of the assembly
Poor durability of ball bearings, whereby there are such defects as "knock" and "creaking" ball bearing.
Factors influencing the premature wear of the supports are:
It is not enough reliable protection against ingress of ball joint, water and dust.
The poor quality of the ball stud (high roughness of the sphere, the deviation from roundness).
Poor wear material inserts the ball stud and a high coefficient of friction


 
Ball joints produced by "ace" have the following advantages to significantly increase the strength and durability of the ball joint:
Housing ball stud is made of forged high-quality structural steel, allows to withstand high loads in the hull structure laid solutions to significantly improve tear-out force and squeezing the ball stud
Protective cover ball stud is made of oil and petrol resistant rubber, held multiple checks in operation at Russian roads.
Ball pin is made of steel, in accordance with European standards by cold heading, heat-treated and has a high quality of processing sphere.
Inserts ball stud made of special plastic, for use in friction pair with steel, have a very low coefficient of friction against steel, high wear resistance, eliminate such a defect as "creaking".
Technology assembly of ball bearings, the level of production control ensures their high consumer quality.